* Increased Impact Strength from 100% 4140 chrome moly heat treated body.
* Increased abrasion resistance from full melonite nitride finish.
* Quick lock Acme threads for 300% more thread engagement with fewer turns.
* No time delay fuse-Fires on impact with any hard surface.
* Output of 120 dB or 175 dB, 4 psi over pressure, & bright flash.
Less smoke than ATF regulated devices.
For Public Safety and Military Training ONLY, not for entertainment or casual use.
WARNING: The PR-FBT Mark 4 training device is potentially dangerous if used improperly.
It can produce dangerous sound levels of up to 180dB, and all users and trainees MUST have adequate hearing protection on when using the full power blanks.
All users and trainees must wear eye protection.
While the device does not fragment, it produces approximately 4 psi overpressure and can send sand, gravel, dirt and floor debris several feet from the point of blast.
This device is for public safety, and military training only. It is not a toy and must be used by experienced and qualified tactical training personnel only.
PRIMER operation: Produces 120dB sound and small flash.
Users must practice with primer before using the full power blanks.
Never throw the device directly at any person!
209 Primer use:
-Insert the black primer holder in the lower half of the device.
-Insert a 209 primer into the holder and screw the top half back on.
-To deploy, grasp the device in the throwing hand with the spoon in the web of the hand aligned with the knuckles.
-Pull the safety pin with the off hand and hold on to it. DO NOT THROW THE PIN AWAY.
-Throw the device into the room so that it hits the floor, wall, or other HARD object.
-The device will fire on impact with a hard object. There is NO TIME DELAY. It is fired by the inertia firing pin on impact with any hard object.
FULL POWER BLANK operation: Produces 170-180 dB sound, bright flash, and 4 psi overpressure.
-Never throw the device directly at any person!
-Full Power Blank use:
-Insert a full power blank cartridge into the lower half of the body and screw the top half back on.
-To deploy, grasp the device in the throwing hand with the spoon in the web of the hand aligned with the knuckles.
-Pull the safety pin with the off hand and hold on to it. DO NOT THROW THE PIN AWAY.
-Throw the device into the room so that it hits the floor, wall, or other HARD object.
-The device will fire on impact with a hard object. There is NO TIME DELAY. It is fired by inertia firing pin on impact with a hard object.